Before installation
- The tray or tiled floor must be finished, watertight and sloped towards the drain.
- Check that the wall is plumb: the adjustment range of ±20 mm on each side compensates for a slight deviation.
- Tempered glass cannot be cut or drilled: check the dimensions before installation.
- Handle the panel with two people, without knocking its corners or edges.
Installation, step by step
- Offer up the wall profile, check that it is plumb and mark the holes.
- Check for cables and pipes, drill and fix the profile with suitable wall plugs.
- Insert the glass panel into the profile with its seals and packers.
- Set the glass plumb within the ±20 mm range, then tighten the locking screws.
- Fix the stainless steel support bar between the glass and the wall, following the instructions.
- Run a sanitary silicone joint along the wall profile, on the outside of the shower.
- Let the silicone cure for 24 hours before the first shower.
Everyday care
- After each shower, use a squeegee on the glass: it is the habit that prevents limescale most.
- Clean the glass with soapy water or a mild glass cleaner and a microfibre cloth.
- For limescale marks, use a mild descaler suited to glass, rinse immediately and keep it off the profiles.
- Wipe the profile and the bar with a soft cloth and a pH-neutral detergent.
- Replace the seals when they are worn.
What to avoid
- Abrasive pads, steel wool, scrapers and blades on the glass.
- Acetone, solvents and chlorine-based products on the chrome profile and the stainless steel bar.
- Knocks on the edges and corners of the glass.
- Hanging from the support bar.
Seals are wear parts and are not covered by the warranty.